« Back to Product

Documentation

Examples

Supplement to KNX: Examples for temperature values and shutter control with KNX.

Sending temperature values to the KNX bus

In order to be able to send values such as the temperature to the KNX bus, an action script is required. This forms the link between the visualization and the actuators. A script with the following content must be created:

EIB_Value(IPS_GetParent($_IPS['VARIABLE']), $_IPS['VALUE']);

For each desired device that should be changeable, the corresponding variable must be linked to this action script. This must be done in the configuration of the respective variable. To do this, the variable must be double-clicked. The selection of the action script is located in the "Profile settings" area. Here, the script just created must be selected. In addition, a suitable profile (e.g. ~temperature) should be selected via "Own profile".

variable-profile
Warning

The last step can be repeated as often as needed. It is only necessary to create the script once with the above mentioned content

Better Shutter Control with KNX Shutter

Due to the many setting options and linked addresses, shutters cannot be added via the configurator.

Shutter configuration

Move

Here the address for the up and down movement of the shutter must be entered. In the area "More?" further addresses can be entered on which the instance for moving up/down should listen.

Stop

Here the address for stopping the shutter must be entered. In the "More?" area, further addresses can be entered to which the instance is to listen for stopping.

Activate_steps/Slat

This address can be enabled and controls the stepwise movement of the shutter. This is used to adjust the slats of the shutter. In the "More?" area, further addresses can be entered to which the instance for step control should listen.

Activate percentage positioning

These two addresses can be enabled and control either the percentage positioning of the shutter or the slats.

Test Center

In the Test Center basic functions can be tested adhoc.

Any questions?